EASY Grout Flow
A high-quality slurry grout for use on porcelain.
- Designed specifically for ceramic and porcelain tiles for a fine, textured finish
- A cementitious grout which is applied as a slurry unlike traditional floor tile grouts
- Easy to use. Simply mix, pour, squeegee and clean
- Coverage: up to 34m²* per tub
- EASYGrout Flow is available in a range of colours and is suitable for joints from 2mm to 25mm wide with a minimum depth of 10mm
- Now with one 15kg bag per tub. Less packaging-better for the environment
*Depending on joint dimension
EASYGrout Flow mixes readily with water to give a highly flowable joint filling, and grouting mortar ideal for use on interior and exterior tiled floor surfaces where a high early strength, resilient, compact grout joint is needed, particularly in areas subject to early and sustained trafficking.
It is not suitable for use on vertical surfaces. It is designed specifically for ceramic and porcelain tiles and is not recommended for use on natural stone. Natural stone and porous materials are particularly at risk from permanent discolouration.
Product
Swatches
Argent
Crema
Grafito
Installation
Guide
Step 1: Prepare
Tiles and joints should be clean and free from debris. Ensure tiles are dampened prior to grouting. Avoid standing water on the paving and in the joints.
Step 2: Mix
Add powder to clean, cold water. Using a powered paddle, slowly mix for 3-5 minutes to form a smooth, lump-free slurry.
Top Tip! Add an additional 100ml of water if grout is not flowable.
Step 3: Apply
Either pour the slurry grout over a small area and spread into the joints using a rubber squeegee or pour along the grout-lines to minimise spread and clean-up.
Top Tip! Apply when tiles are cool to touch.
Step 4: Clean
Remove as much grout residue as possible using the squeegee. Then, use a tilers sponge and bucket with a residue trap to remove any remaining grout residue remembering to change the cleaning water regularly. Be careful to avoid pulling out any grout.
Step 5: Finish
Once the grout has hardened, clean the tile surface thoroughly and any remaining grout or haze can be removed using Azpects Grout Residue Cleaner.
Frequently Asked
Questions
Yes, EASYGrout Flow is an interior and exterior product.
Yes, EASYGrout Flow is compatible with underfloor heating.
Yes, generally, adding another 100mls of water will create a good slurry. Just make sure all mixes for the specific area are made equal.
This will be efflorescence hydrating to the surface. This can happen if there is too much water in the mix or left on the surface of the grout after final cleaning. The joint surface should be as dry as possible after application.
Its easy to do. Use EASYCare Grout Residue Cleaner *
* Not for use on natural stone
Staining can occur if the cleaning process is not carried out carefully. Therefore, it is important to change the cleaning water regularly.
The specified amount is on the packaging. You can use more or less water to make a slurry paste which flows freely. Please ensure each mix after that is consistent.
Using EASYGrout Flow on any natural stone or concrete is not recommended due to the risk of staining.
Dark or patchy spots are a result of moisture in the joint. Colours will become more uniform as the joint dries out.
Depending on the aspect of the garden, algae can grow on surfaces, including joints. This can be cleaned using EASYCare Algae Remover.
White joints are caused by efflorescence, which hydrates as the grout dries. This can be cleaner with EASYCare Grout Residue Cleaner.
EASYGrout Flow uses a very fine cement powder that can remain on the tile surface after cleaning but can be removed with EASYCare Grout Residue Cleaner.
You can use EASYCare Grout Residue Cleaner
