5 General Information & Precautions (Continued) Setting Times. In dry conditions and warm to moderate temperatures and humidity, EASYJoint should be firm enough to walk on within 24 hours and will cure very hard within a few days. Cold and wet conditions increases the setting time considerably. Freezing weather will cause the process to virtually cease and it can take many days for the joints to set hard. However EASYJoint will eventually set and the joints’ integrity will not be impaired in any way. While EASYJoint remains wet, either from the application procedure or through rainfall, the curing process will be suspended. Prolonged rainfall or several intermittent showers will considerably extend the setting times. Again, this will not affect the final integrity of the product provided the water can drain away and allow even curing throughout the joints (as previously explained). Clean-up. Work cleanly, clearing both the sand grains and the binding oil from the surface as you go. Keep washing until the “rainbow effect” oily water is no longer evident. Once EASYJoint has set hard in the joints, sweep the paving with a stiff broom, diagonally to the joints, to remove any final traces of compound, especially along the edges of “struck” joints. Do not use the same broom that was used in the application process. Unused but opened EASYJoint can be saved for later use by pouring it back into the tub (not in the bag) and covering it with at least 2” of water. The product should remain usable for many months. EASYClickBase The EASYway to create a strong foundation for patios, paths and driveways • Less labor • Less waste • Less aggregate • Saves time • Saves money For further information: azpects.com
RkJQdWJsaXNoZXIy NDUxNTk=